BMW 5 Series: Auto PDC
On the G30, Auto PDC is activated automatically if the vehicle is approaching an object at a speed below approximately 3 mph (5 km/h) and the object is located in a collision-critical area. The Auto PDC function is available for both the front and rear of the vehicle.
The automatic switch-on function when obstacles are detected can be switched on and off via iDrive.
Further information about Auto PDC may be found in the "G12 Driver Assistance Systems" reference manual.
Active Park Distance Control
In G30 vehicles with the Parking Assistant, optional equipment (OE 5DM), or Parking Assistant Plus, (OE 5DN) optional equipment, the Park Distance Control function has been extended to include the Active Park Distance Control function. This automatically brakes the vehicle to a stop when it is travelling at walking speed ( < approximately 4 mph (6 km/h) ) if an object is detected behind the vehicle.
The Active Park Distance Control function can be switched on and off via iDrive.
The system does not relieve the driver of personal responsibility for correctly judging the traffic situation. The driver should check the traffic conditions and the vehicle's surroundings by looking around and react accordingly if required.
Further information about the Active Park Distance Control function may be found in the "G12 Driver Assistance Systems" reference manual.
READ NEXT:
Side protection
The side protection warns against obstacles at the side of the vehicle and
thus supports the driver
when parking and maneuvering.
G30 Side protection
Vehicles with the Parking Assistant, optional eq
Operation
The Park Distance Control system is enabled in the following situations:
If drive position R reverse gear is engaged when driving readiness is
switched on.
If the parking assistance button in the
Limits of the system
Due to the physical limits during the ultrasonic measurement, obstructions
may not be detected by the
Park Distance Control system. Several examples of this are shown below:
If the objects are thin
SEE MORE:
Direct rail
Mounting the injectors
Mounting bolts
Plastic sleeve
Holding clamp with bayonet fitting
Rail
Solenoid valve injector
Cast lug
The solenoid valve injectors are fastened to the holding clamp with a bayonet
fitting. There is a plastic
sleeve between the holding clamp and direct rail. This is
SYNC program
Concept
Depending on the equipment, the following settings
of the driver's side can be transferred to the
front-passenger side and the rear:
Temperature.
Air flow.
Air distribution.
AUTO program.
Switching on/off
Press the button.
The LED is illuminated with the SYNC
program switched on.
The
