BMW 5 Series: Switching on/off
Switching on
Press the button on the steering
wheel.
Steering wheel symbol lights up
gray.
The system is on standby and does not
manipulate steering.
System activates automatically as soon as all
function conditions are fulfilled.
Steering wheel symbol lights up
green.
The system is active.
With the system switched on, the person warning
with City braking function and the side collision
mitigation are active.
Switching off
Press the button on the steering
wheel.
The indicator goes out.
The system does not perform supportive steering
wheel movements.
Interrupting automatically
The system is automatically interrupted in the
following situations:
- At a speed above 130 mph/210 km/h.
- When the steering wheel is released.
- When you manipulate steering.
- When you leave your own lane.
- When the turn signal is switched on.
- When the lane is too narrow.
- If for a particular time no lane marking is detected
and there is no vehicle driving in front.
Steering wheel symbol lights up
gray.
The system is on standby and does not
manipulate steering.
System activates automatically as soon as all
function conditions are fulfilled.
READ NEXT:
Gray steering wheel symbol:
The system is on standby.
Green steering wheel
symbol:
The system is activated.
Yellow steering wheel symbol
and a signal sounds, if applicable:
System interrupt
General information
The system cannot be activated or meaningfully
used in certain situations.
Safety information
Warning
The system is designed to operate in certain
conditions and circumstances. Due
SEE MORE:
Concept
If the vehicle is in idle state, it is switched off. All
power consumers are deactivated.
General information
The vehicle is in idle state prior to opening from
the outside and after exiting and locking.
Safety information
Warning
An unsecured vehicle can begin to move and
possibly roll away
On the G30 the stratification for the driver/front passenger is not adjusted
in the usual manner by the
knurled wheels on the front dash panel. Instead, there is a menu button located
in the center of the
IHKA control panel. Pressing this button opens the IHKA menu in the CID. Once
the menu is di