BMW 5 Series: Turn signal, high beams, headlight flasher
Turn signal
Turn signal in exterior mirror
When driving and during operation of the turn signals or hazard warning system, do not fold in the exterior mirrors, so that the signal lights on the exterior mirror are easy to see.
Using turn signals
.png)
Press the lever past the resistance point.
Triple turn signal activation
Lightly tap the lever up or down.
The triple turn signal duration can be adjusted.
Via iDrive:
1. "My Vehicle".
2. "Vehicle settings".
3. "Lighting".
4. "Exterior lighting".
5. "One-touch turn signal".
6. Select the desired setting.
The setting is stored for the driver profile currently used.
Signaling briefly
Press the lever to the resistance point and hold it there for as long as you want the turn signal to flash.
High beams, headlight flasher
Push the lever forward or pull it backward.
.png)
- High beams on, arrow 1.
The high beams light up when the low beams are switched on.
- High beams off/headlight flasher, arrow 2.
READ NEXT:
Wiper system
General information
Do not use the wipers if the windshield is dry, as
this may damage the wiper blades or cause them
to become worn more quickly.
Safety information
Warning
If the wipers start moving
Washer fluid
General information
All washer nozzles are supplied from one reservoir.
Use a mixture of tap water and windshield
washer concentrate. If desired, a windshield
washer concentrate containing antifreeze
Steptronic transmission
Concept
The Steptronic transmission combines the functions
of an automatic transmission with the possibility
of manual shifting, if needed.
Safety information
Warning
An unsecured vehicle can begin to
SEE MORE:
Temperature
Concept
The automatic climate control achieves the set
temperature as quickly as possible, if needed, by
using the maximum cooling or heating capacity,
and then keeps it constant.
Adjusting
Turn the wheel to set the
desired
temperature.
Do not rapidly switch between different
temperature settings
Crankcase
Honing process
Honing process "old/new"
Previous manufacturing process of internal cylindrical honing
New manufacturing process of form honing
The cylindrical bore hole of a combustion engine becomes deformed during the
operating condition
by thermal loads. Form honing allows this deformation
