BMW 5 Series: Setting brightness and contrast
Brightness and contrast can be adjusted with Surround View or Panorama View switched on.
Via iDrive:
1. Move the Controller to the left.
2.
.png)
"Brightness".png)
"Contrast"
3. Set the desired value.
Functional limitations
The system can be used only to a limited extent in the following situations:
- In poor light.
- In case of soiled cameras.
- With a door open.
- With the trunk lid open.
- With exterior mirrors folded in.
Gray hatched areas with symbol, for instance open door, in the camera image mark areas that are currently not displayed.
System limits
Non-visible areas
Because of the camera angle, the areas under the vehicle cannot be viewed by the cameras.
Detection of objects
Very low obstacles as well as high, protruding objects such as ledges may not be detected by the system.
Some assistance functions also consider data from the PDC Park Distance Control.
Follow the notes in the PDC Park Distance Control chapter.
The objects displayed on the Control Display may be closer than they appear. Do not estimate the distance from the objects on the display.
Malfunction
A camera malfunction is displayed on the Control Display.
.png)
A yellow symbol is displayed
and the recording
range of the malfunctioning camera
is displayed in black on the Control
Display.
Remote 3D View
Concept
With the proper equipment, the BMW Connected App and the camera images from Surround View can be used to display the vehicle surroundings on a mobile device such as a smartphone.
The function displays a momentary view of the situation.
Functional requirements
- Data transmission must be activated.
- BMW Connected App must be installed on the mobile device.
Switching the function on/off
Via iDrive:
1. With the standby state switched on: "My Vehicle".
2. "iDrive settings".
3. "Data privacy".
4. "Remote 3D View".
Functional limitations
The system may not be fully functional or may not be available in the following situations:
- In poor light.
- In case of soiled cameras.
- With a door or the trunk lid open. Dark fields in the display indicate areas that are not recorded by the system.
- With exterior mirrors folded in.
- When other camera functions are being performed in the vehicle.
- When the vehicle moves faster than walking speed.
- It may not be possible to use the function in every country.
- For reasons of data protection, the function can only be used three times within two hours.
READ NEXT:
Concept, General information, Safety information
Concept
The system supports parking in the following situations:
When parking parallel to the road, parallel
parking.
When reverse parking diagonally to the road,
diagonal parking. The system or
Overview
Button in the vehicle
Park assistance button
Ultrasound sensors
With the four side ultrasound sensors, arrows,
and the ultrasound sensors of PDC Park Distance
Control in the bumpers, the parking
sp
SEE MORE:
Overview
Button in the vehicle
Intelligent Safety
Camera
The camera is installed near the interior mirror.
Keep the windshield in front of the interior mirror
clean and clear.
With radar sensor
The radar sensor is located in the lower area of
the front bumper.
Always keep radar sensor clean and unobstr
KAFAS
Since the requirements on the KAFAS camera have further increased in the new
BMW 5 Series, the
KAFAS stereo camera, familiar from the G12, is also used on the G30.
KAFAS stereo camera
The KAFAS stereo camera is calibrated within a distance of approximately 1.25
mi (2 km) during
driving.
The KAFA
