BMW 5 Series: Temperature
Concept
The automatic climate control achieves the set temperature as quickly as possible, if needed, by using the maximum cooling or heating capacity, and then keeps it constant.
Adjusting
.png)
Turn the wheel to set the
desired
temperature.
Do not rapidly switch between different temperature settings. Otherwise, the automatic climate control will not have sufficient time to adjust the set temperature.
Air conditioning
Concept
The air in the car's interior will be cooled and dehumidified and, depending on the temperature setting, warmed again.
The car's interior can only be cooled with the drive-ready state switched on.
Switching on/off
.png)
Press the button.
The LED is illuminated with air conditioning switched on.
Air conditioning is switched on with the engine running.
Depending on the weather, the windshield and side windows may fog up briefly when driveready state is switched on.
The cooling function is switched on automatically with the AUTO program.
When using the automatic climate control, condensation water develops and collects underneath the vehicle.
Maximum cooling
Concept
The system is set to the lowest temperature, optimum air flow and recirculated-air mode with the drive-ready state switched on.
General information
The function is available with external temperatures above approx. 32 ℉/0 ℃ and with the drive-ready state switched on.
Switching on/off
.png)
Press the button.
The LED is illuminated with the system switched on.
Air flows out of the vents to the upper body region.
The vents need to be open for this.
Adjust air flow on the driver's side with the program active.
READ NEXT:
AUTO program
Concept
The AUTO program cools, ventilates or heats
the car's interior automatically.
The air distribution and temperature are controlled
automatically depending on the temperature
in the car's inter
SYNC program
Concept
Depending on the equipment, the following settings
of the driver's side can be transferred to the
front-passenger side and the rear:
Temperature.
Air flow.
Air distribution.
AUTO program.
Ventilation
Concept
The air flow directions can be individually adjusted.
Adjusting the ventilation
General information
The air flow directions can be adjusted for direct
or indirect ventilation.
Open the vents
SEE MORE:
Hazard warning flashers
The button is located in the center console.
The red light in the button flashes when the hazard
warning flashers are activated.
Warning triangle
The warning triangle is located on the inside of
the trunk lid.
Press on the release, arrow 1, and swivel the
cover down, arrow 2.
First-aid kit
Gener
Introduction
New features in the G30
The G30 builds on the technology introduced in the 7 Series (G12). This
Training manual describes
the new features or changes with regard to the G12.
The table below lists the new features and changes in the G30 compared to the
G12:
Further information
The functions in th
