BMW 5 Series: Start/Stop button
Concept
.png)
Pressing the Start/Stop button
switches drive-ready state on or off.
Steptronic transmission: the drive-ready state is switched on when you depress the brake pedal while pressing the Start/Stop button.
Pressing the Start/Stop button again switches drive-ready state back off and standby state is switched back on.
Driving away
1. Switch on drive-ready state.
2. Apply drive mode.
3. Release the parking brake.
4. Drive away.
Drive-ready state
Safety information
DANGER
If the exhaust pipe is blocked or ventilation is insufficient, harmful exhaust gases can enter into the vehicle. The exhaust gases contain pollutants which are colorless and odorless. In enclosed areas, exhaust gases can also accumulate outside of the vehicle. There is danger to life. Keep the exhaust pipe free and ensure sufficient ventilation.
Warning
An unsecured vehicle can begin to move and possibly roll away. There is a risk of accident.
Before exiting, secure the vehicle against rolling.
In order to ensure that the vehicle is secured against rolling away, follow the following:
- Set the parking brake.
- On uphill grades or on a downhill slope, turn the front wheels in the direction of the curb.
- On uphill grades or on a downhill slope, also secure the vehicle, for instance with a wheel chock.
NOTICE
In the case of repeated starting attempts or repeated starting in quick succession, the fuel is not burned or is inadequately burned. The catalytic converter can overheat. There is a risk of damage to property. Avoid repeated starting in quick succession.
Switching on drive-ready state
Steptronic transmission
1. Depress the brake pedal.
2. Press the Start/Stop button.
The ignition is activated automatically for a brief time and is stopped as soon as the engine starts.
Most of the indicator/warning lights in the instrument cluster light up for a varied length of time.
Gasoline engine
Depending on the motorization, the full drive power may not be available for approximately 30 seconds after starting the engine. In this case, the vehicle will not accelerate as usual.
Display in the instrument cluster
When drive-ready state is switched on, the tachometer shows the current engine speed.
Switching off drive-ready state
Steptronic transmission
1. Engage selector lever position P with the vehicle stopped.
2. Press the Start/Stop button.
The engine is switched off.
3. Set the parking brake.
READ NEXT:
Auto Start/Stop function
Concept
The Auto Start/Stop function helps save fuel.
The system switches off the engine during a
stop, for instance in traffic congestion or at traffic
lights. Drive-ready state remains switched on.
Parking brake
Concept
The parking brake is used to prevent the vehicle
from rolling when it is parked.
Safety information
Warning
An unsecured vehicle can begin to move and
possibly roll away. There is a risk of ac
Turn signal, high beams,
headlight flasher
Turn signal
Turn signal in exterior mirror
When driving and during operation of the turn
signals or hazard warning system, do not fold in
the exterior mirrors, so that the signal lights on
the exterio
SEE MORE:
Control units on the FlexRay
Advanced Crash Safety Module (ACSM)
Advanced Crash Safety Module (ACSM)
The function of the Advanced Crash Safety Module (ACSM) is to evaluate all
sensor signals in order
to identify a crash situation. The ACSM evaluates the information from the
sensors and then forwards
corresponding measures fo
Comfort Access
System wiring diagram
Comfort Access
Body Domain Controller (BDC)
Fuse in the Body Domain Controller
Switch in door lock of front passenger door
Outside door handle electronics (TAGE), front passenger door
CAN terminator
Comfort Access antenna, side sill, right
Switch in door lock of rear p
