BMW 5 Series Owners & Service Manuals

BMW 5 Series: Rear collision preparation

BMW 5 Series 2016-2024 Owners Manual / Safety / Rear collision preparation

Concept

The system reacts to vehicles approaching from behind.

General information

Two radar sensors in the rear bumper monitor

Two radar sensors in the rear bumper monitor the area behind the vehicle.

When a vehicle approaches from the rear at a certain speed, the system responds as follows:

  • Active Protection: when a collision seems to be unavoidable, PreCrash functions are triggered.

Safety information

Warning

The system cannot serve as a substitute for the driver's personal judgment in assessing visibility and traffic situation. There is a risk of accident.

Adjust driving style to traffic conditions. Watch traffic closely and actively intervene where appropriate.

Warning

Indicators and warnings cannot serve as a substitute for the driver's personal judgment. Due to its limits, the system may not issue warnings or reactions, or these may be issued late or in a manner that is not consistent with their normal use. There is a risk of accident. Adjust driving style to traffic conditions. Watch traffic closely and actively intervene where appropriate.

Overview

Radar sensors

The radar sensors are located in the rear

The radar sensors are located in the rear bumper.

Always keep the bumper in the area of the radar sensors clean and unobstructed.

Switching on/off

The system is automatically active after every driving off.

The system is deactivated in the following situations:

  • When driving in reverse.

System limits

The system may not be fully functional in the following situations:

  • When a vehicle is approaching at a speed much faster than your own.
  • When the approaching vehicle approaches slowly.
  • In heavy fog, wet conditions, or snowfall.
  • In tight curves or on narrow lanes.
  • If the bumper is dirty, iced up, or covered, for instance by stickers.
  • If the field of view of the sensors is covered, e.g., by garage walls, hedges or snow hills.
  • If cargo protrudes.

    READ NEXT:

     Active Protection

    Concept Active Protection prepares occupants and the vehicle for a possible accident in critical driving or collision situations. General information Active Protection consists of various PreCrash fun

     PostCrash - iBrake

    Concept In the event of an accident, the system can bring the vehicle to a halt automatically without intervention by the driver in certain situations. This can reduce the risk of a further collision

     Driving stability control systems

    SEE MORE:

     Timeshift

    General information The channel you are currently listening to is stored in a buffer for up to an hour. Prerequisite: the signal must be available. The stored audio track can be played with a delay following the live broadcast. When the memory is full, the older tracks are overwritten. The memory

     Crash-relevant functions

    The Advanced Crash Safety Module must fulfil the following crash-relevant functions: Evaluating the sensor signals Impact detection Determining actuators to be activated Specifying the trigger time and trigger sequence Activation of the ignition circuit output stages Sending the crash messag

    © 2019-2024 Copyright www.bmw5g30.com